Advertisement
Align the lower hole on the pipe bracket (D) with
the respective hole on the chassis.
Holding the pipe bracket (D) in the correct
installation position, mark the positions on the
chassis of the upper holes indicated.
Loosen the hose clamp (1).
Open the rubber lined clip (2) by undoing the
indicated screw.
Disconnect and remove the pipe (D).
Use a suitable drill with a helical bit Ø 9 mm (0/+
0.1), drill holes in the positions marked
corresponding to the upper holes on the rigid
pipe bracket.
Use a suitable tool to insert and fasten the
indicated riveting nuts in the holes.
Advertisement
