Advertisement
Detach the eyebolt on the EPB Bowden cable from the relevant fork inside the hub carrier.
Detach the tie-rod (1) for the NRRPS motion
sensor from the lower arm.
Disconnect the connector (2) for the brake pad
wear sensor.
Disconnect the connector (3) for the ABS sensor.
Detach the cable grommet (4) from the relevant
mounting bracket.
Cut the cable tie (5) for retaining cables.
Detach the cable grommet (6) from the relevant
bracket on the EPB Bowden cable sheath (8).
Undo the nut (7) fastening the ground cable onto
the bracket on the EPB Bowden cable sheath
(8).
Undo the indicated screw fastening the EPB
Bowden cable sheath (8) onto the hub carrier.
Remove and retrieve the clip (9) fastening the
union for the brake fluid hose (11) onto the
relevant mounting bracket.
Undo the brake fluid hose union (10).
Extract the brake fluid hose (11) from the
relevant mounting bracket.
Advertisement
