Advertisement
Set the glass panel carefully on a stable surface so that it is not scratched or damaged.
Degrease the perimeter of the glass with DOW BETACLEAN 3300 P/N 81636500 and leave to dry.
Fasten the locator tab (1) to the bodyshell,
pressing the relative pin downwards, then fit
the adjustable spacer (2).
Apply DOW BETAPRIME 5500 Green cap to
the entire perimeter of the glass between the
two dotted lines in the figure and leave the
product to dry for approximately 10 minutes.
The inner dotted line at the top and side of the
glass overlaps the solid screen-printed area
by approximately 10 mm.
Apply adhesive primer in a uniform,
uninterrupted bead.
Using an extrusion gun fitted with a triangular
section nozzle, apply a continuous bead (3) of
DOW BETASEAL 1812, starting from the mid
point of the bottom side.
The end of the bead must overlap the
beginning by approximately 20-30 mm.
Advertisement
