Advertisement
Press the power window button and check that the quarterlight rolls without resistance and stops in the
correct position.
Should it be necessary to adjust the quarterlight,
remove the filler foam rubber (15) and then
the rubber cap (16) on the recess for the
quarterlight preload adjuster dowel.
To adjust correctly, the internal window scraper
seal (14) for the quarterlight must be removed.
IT IS IMPORTANT however that all adjustment
checks are carried out with the seal (14)
installed. If it is not in place, the value read
may be false.
During any adjustment to the quarterlight, the
outer nut (1) fastening the quarterlight preload
adjustment dowel (2), located on the
bodyshell behind the lower lateral trim panel,
must be completely loosened.
Should it be necessary to adjust the quarterlight,
loosen the nut (1) while holding the adjuster
dowel (2) still to prevent it from turning. The
nut will be tightened again only once the
adjustment procedure is complete.
Advertisement
