Advertisement
If the level is too low, identify the cause of excessive oil consumption.
If topping up is necessary (no fluid flowed out of hole when plug was removed), proceed as follows.
Use a pump to aspirate the specified oil from a new container.
Using the pump and a container for collecting excess oil, top up via the level pipe until excess oil overflows
from the orifice of the cap removed previously.
Let the oil fluid completely until the flow stops.
The level is correct when fluid stops flowing out of the hole.
The oil level MUST be checked within 10
minutes of switching off the engine.
5) Undo the threaded plug (A) on the left hand
side of the gearbox, and check the level: the
level must reach the edge of the hole from
which the plug was removed, on the limit
of overflowing.
Tighten the threaded plug (A).
Tightening torque
Plug
Nm
Class
49 Nm
B
Advertisement
