Advertisement
Refit the complete quarterlight (
Detach the rear section of the window scraper
Remove the window scraper seal (A) from the
Fit the new window scraper seal (A) in the
Press along the whole length of the seal to seat
Tighten the four screws indicated fastening the
Tightening torque
Screw
E3.07).
Fit the front part of the window scraper seal (A),
seal (A).
relative seat and replace.
relative seat, fitting onto the rear lip and
fastening the rubber peg into the relative
square hole in the bodyshell.
correctly on the lip.
window scraper seal (A).
fastening by fitting the two rubber pegs into
the respective square hole in the bodyshell
and applying a strip of double sided adhesive
tape or a small quantity of 3M.
Nm
Class
2.5 Nm
C
Advertisement
