Advertisement
If the measurements comply within the values indicated
Check the tension of the exhaust system vibration dampers (
If one or more of the measurements do not comply with the values indicated
Adjust the exhaust system (
Checking tension of exhaust system vibration dampers
Remove the rear flat undertray diffuser (
Remove the rear flat undertray section (
Remove the rear wheelhouses (
Remove the rear elements of the rear wheelhouses.
B7.01).
E3.12).
E3.12).
E3.05).
B7.01).
Measure the lower slot on the exhaust system mounting vibration
dampers (1).
The slot must measure ≥ 4 mm.
The
example
in the
photo
illustrate
s how
to
visually
identify
an Z
axis
alignme
nt error
(NOT
OK)
between
the two
catalytic
converte
rs, with
a
vertical
differenc
e
exceedi
ng 6
mm.
Advertisement
