Advertisement
Refit the battery (
Fill and bleed the brake system (
Refit the front flat undertray section (
Refit the engine compartment cosmetic shields (
Always perform a complete operating cycle after replacing the electrohydraulic ABS/ASR unit.
Removing the front wheel ABS sensor
Disconnect the battery (
Remove the wheels (
F2.01).
D3.10).
E3.12).
F2.01).
D2.01).
Fit and fasten the cover (8) on the ABS/ASR
electrohydraulic unit, pressing the two clips
indicated.
E3.13).
Remove the indicated clamps.
Disconnect ground cable from the indicated clip.
Detach brake pad wear sensor cable from cable
grommet (1).
Detach cable grommet (1) of ABS sensor cable
from the relevant mounting bracket.
Release and disconnect connector (2).
Advertisement
