Advertisement
Fit the brake calliper (45) in its seat on the hub
carrier and fasten by tightening the screws
(46).
Repeat the procedure for the right hand brake
calliper.
Tightening torque
Screw
Working on the left hand rear suspension, fasten
the clamp on the parking brake cable (43), by
hand tightening the relevant nut.
Connect the vehicle motion sensor connector
(42).
Connect the ABS sensor connector (41) and
fasten the connector to the bracket on the
centre chassis.
Fit new plastic clamps in the positions indicated.
Fasten the ground cable (39) onto the
suspension bracket, by hand tightening the
nut (40).
Repeat all the previous procedures for the right
hand rear suspension.
Tighten the screws (38).
Tightening torque
Screw
Connect the connector (37) onto the shock
absorber.
Nm
Class
100 Nm
A
Nm
Class
30 Nm
A
Advertisement
