Advertisement
Check the Shell Transaxle 75W-90 GL5 gear oil level (
Check that there is no leakage from the drain plugs and from the delivery and return unions disconnected
during the draining procedure.
Filling the system with Shell Transaxle 75W-90 GL5 gear oil (ONLY for vehicles WITH single oil heat
Connect the unions (5) for the gear oil pipes and
fasten the clamp (4) to the bodyshell.
Fasten the mounting bracket (3) for the gear oil
pipes, by tightening the screws indicated with
relevant washers.
Tightening torque
Screw
Replace the plugs (1) and (2), fitting and
tightening the new components.
Tightening torque
Plug
Using the pump
(AV
short spout), aspirate the specified oil from a
newly opened container.
Using the pump
(AV
container for collecting excess oil, fill with 4.9
litres (2.9 litres + approx. 2 litres for external
cooling circuit) of oil via the level check/filler
hole.
Fill with half of the quantity indicated, wait a few
minutes for the fluid to settle, then gradually
finish filling, until oil overflows from the
check/filler hole.
The quantity of oil required may vary slightly
relevant to the amount indicated for filling
the tank when empty; this is due to
unavoidable pooling within the system. Fill
gradually.
A3.02).
Nm
20 Nm
Nm
25 Nm
8174) element 01 (with the
8174) element 01 and a
Class
B
Class
B
Advertisement
