Advertisement
Fit the shims (5) in the relative seats, pushing
down completely onto the stud bolts and
ensuring that they are perfectly perpendicular
to the horizontal axis of the Flanblocs.
Clean the mating surfaces with a degreasing
product (heptane).
DO NOT use lubricants or electric/pneumatic
drivers.
ALWAYS replace the suspension arm
fastener nuts, complete with relative
washers, each time they are removed.
Replacement is NOT necessary if the nuts
are loosened only.
Tighten the indicated nuts fastening the lower
arm (A) in the following order: (a), (b), (c), (d).
Tightening torque
Nut (pretightening)
Nut
Check that the yellow reference markings are
correctly aligned: the markings on the stud
bolts and the markings on the Flanbloc
eyebolts must be aligned.
Remove the yellow reference markings made
during removal.
Using an indelible red marker pen or paint, make
reference markings on the stud bolts and
relative nuts and the eyebolts of the Flanblocs
fastening the lower arm.
Nm
Class
25 Nm
A
60 Nm
A
Advertisement
