Advertisement
Refit the wheels (
Connect the battery (
Only in the case of replacing the pads. Bed-in the CCM brake pads (
Removing the rear brake pads
Disconnect the battery (
Remove the wheels (
Remove the rear wheels.
D2.01).
F2.01).
F2.01).
D2.01).
Install the brake pads (A).
Install the pin (7).
Tighten the screw (6).
Tightening torque
Screw
Install the pin (5), tapping with a suitable punch
and mallet.
Fit the spring (4).
Install the pin (3), tapping with a suitable punch
and mallet.
Slide connector (1) of brake pad wear sensor
under ABS sensor cable, connect it, and
attach it to the relative mounting bracket.
Connect brake pad wear sensor cable to the
cable grommet (2).
Tighten new cable ties in the positions indicated.
A3.19).
Nm
Class
27 ÷ 33 Nm
0
Advertisement
