Advertisement
If the measurements comply within the values indicated
Refit the rear wheelhouses (
Refit the rear sections of the rear wheelhouses.
Refit the central flat undertray section (
Refit the rear flat undertray section (
Refit the rear flat undertray diffuser (
If one or more of the measurements do not comply with the values indicated
Adjust the tension of exhaust system vibration dampers (
Adjusting the exhaust system
Tightening torque
Catalytic converter - exhaust manifold
Catalytic converter clamp - mounting bracket
Centre silencer - catalytic converter
Exhaust extension - centre silencer
Fastening silencer connector cross member
Exhaust extension - silencer
Damper - central silencer
Check the alignment of the exhaust system (
Remove the central flat undertray section (
Perform only in the event of Z axis misalignment.
Remove the centre silencer (
Perform only if is necessary to replace the exhaust system fastener clamps.
E3.05).
E3.12).
E3.12).
E3.12).
Nut
Nut (pretightening)
Nut
Torx clamp
Torx clamp
Screw
Nut
Spherical clamp
Nut
B7.01).
E3.12).
B7.04).
Apply Copper based grease for high temperatures uniformly
B7.01).
Nm
25 Nm
15 Nm
25 Nm
54.2 Nm
54.2 Nm
25 Nm
25 Nm
35 Nm
25 Nm
on the entire straight section of the exhaust system mounting
pins.
Class
B
0
B
B
B
B
B
B
B
Advertisement
