Advertisement
Apply the new adhesive foam rubber (14) onto
the active carbon filter, as shown in the photo
aside.
Fit the active carbon filter, complete with bracket
and filter for the OBD pump, into its seat, via
the aperture at the rear of the vehicle.
Fasten the front of the active carbon filter by
tightening the screw (10).
Tightening torque
Screw
Connect the pipe (14) to the fuel vapour
separator (16).
A double-lock safety clip is fitted on the pipe.
After connecting the quick connector fuel pipe
correctly, with due caution and pressing on
both sides of the double-lock clip, push the
clip into its seat until it clicks audibly into
place and the pipe is secured correctly.
The difference between the safety
clip "unclicked" and "clicked" position is only
a few millimetres.
Nm
Class
24 Nm
B
Advertisement
