Advertisement
Tightening torque
Fastening hinges - luggage compartment lid
Fastening hinges - Tonneau Cover
Fastening luggage compartment lid striker plate
Before removing any fastener clamps and/or clips in the electronic system and/or hydraulic system,
note the number and position of the components to ensure that they are refitted correctly during
reassembly.
Adequately support the weight of luggage compartment lid.
This operation requires at least two operators.
Fit the luggage compartment lid on the relative hinges, using the markings made during removal as
reference, and fix temporarily with the four fastener screws.
Locate the cables in the luggage compartment so that they cannot be crushed or damaged by moving
components.
Screw
Screw
Screw
If the Tonneau Cover has been removed
Fit the luggage compartment lid, complete with
hinges, on the Tonneau Cover and fix
temporarily with the four fastener screws (14)
(two per hinge).
Locate the cables in the luggage compartment
so that they cannot be crushed or damaged
by moving components.
Adequately support the weight of luggage
compartment lid.
This operation requires at least two
operators.
Feed the antenna cables and the ground cable
through the cable grommet (11) and pull
through as far as the luggage compartment.
Fasten the cable grommet (11) onto the luggage
compartment lid with the clamp (10).
Hand tighten, applying the shims removed during
disassembly, the two screws (12) fastening
the hinge to the luggage compartment lid.
When refitting the same luggage compartment
lid, use the original shims.
When fitting a new luggage compartment lid,
reuse the original shims as an initial
guideline.
Nm
Class
20 Nm
B
20 Nm
B
20 Nm
B
Advertisement
