Advertisement
Remove the rim from the machine and put carefully in a safe place.
If the tyre is not to be refitted immediately, refit the valve core and cap.
Remove the tyre pressure sensors (
Proceed as follows if removal is necessary.
Checking wheel rims
Position the tyre bead on the tool (4) using the
lever (5).
Remove the lever.
Ensure that the entire edge of the bead is
outside the rim and completely visible. If this
is not the case, the bead may be damaged.
If the bead does not slide easily into the
Turn the wheel clockwise.
Position the inflation valve (A) at 12 o'clock.
Fit the lever (5) on the tool (4).
Lift the tyre.
Take care not to damage the sensor when
Position the lower bead of the tyre on the tool
(4), using the lever (5).
Turn the wheel clockwise.
D2.03).
groove, lubricate the contact area.
inserting the tyre lever (5).
Advertisement
