Advertisement
Connect the pipe (10) onto the relative union on
the power steering pump assembly (A) and
fasten by tightening the clamp (9).
Tightening torque
Screw collar
Fit the pipe (8), positioning correctly using the
markings made during removal as reference,
replace the seals and tighten the pipe union
(7).
Tightening torque
Threaded union
Fit the power steering pump assembly (A), with
the relative mountings, in its seat on the
engine.
Fit the screws (11), (12) and (13) fastening the
power steering pump assembly (A), and
screw down until flush but without tightening.
Fit the A.C. compressor (B) into the relative seat
on the engine and, after fitting the arch
bracket (17), fit the screws (14), (15) and (16)
and screw down until flush but without
tightening.
Fit the arch bracket (17) underneath the power
steering pump heat shield mounting bracket.
Connect the connector (18).
Nm
Class
4 Nm
B
Nm
Class
35 Nm
B
Advertisement
