Advertisement
Removing heat shields and DCT gearbox struts
With the gearbox on the workbench and supported correctly, remove the heat shields and the relevant
mounting struts as follows.
Heat shield on right hand axle shaft
Heat shield on left hand axle shaft
Tighten the eye bolts in the relative holes on the
gearbox and fit tool
Connect to a mobile hydraulic jack, lift the
gearbox from the rear removable subframe
and set down in a safe place.
Undo the three screws indicated and remove the
heat shield (3) from the right hand axle shaft.
(AS
107564).
Advertisement
