Advertisement
Tightening torque
Fastening silencer bracket
Exhaust extension - silencer
Fastening silencer connector cross member
FROM Assembly No. 87136, new silencers were introduced to replace the previous units, with specific
rubber pipes for the bypass valves.
ONLY for vehicles UP TO Assembly No. 87135, even if it is necessary to replace one silencer only,
both silencers must be replaced, together with the relative pipes for the bypass valves, with the
NEW components.
As the rubber pipes for the bypass valves are not interchangeable, both the pipes for silencers UP TO
Assembly No. 87135 and the pipes for silencers FROM Assembly No. 87136 will be orderable as
spare parts.
For vehicles UP TO Assembly No. 87135, it is not necessary to replace the pair of silencers when
replacing the rubber pipes for the bypass valves only.
The following process is for refitting the right exhaust silencer.
The process for fitting the left exhaust silencer is identical.
Fit the silencer, inserting via the wheel bay.
Nut
Spherical clamp
Screw
Nut
Support the weight of the silencer (B).
Fit the front bracket (C), aligning the reference
markings.
Fit the plate (3).
Tighten the nuts indicated.
Tightening torque
Nut
Connect pipe (4).
Nm
Class
25 Nm
B
35 Nm
B
25 Nm
B
25 Nm
B
Nm
Class
25 Nm
B
Advertisement
