Advertisement
Fill the cooling system (
Check the Shell Transaxle 75W-90 GL5 gear oil level (
Refit the rear flat undertray section (
Refit the front wheelhouses (
A3.07).
E3.12).
E3.05).
Clean the unions to be connected thoroughly
with a suitable degreaser that does not leave
residue.
Connect the gear oil pipe unions. Follow the
instructions given below to ensure proper
connection:
ensure that the notch on the safety ring nut (14)
is aligned with the pin (13);
connect the male union and turn the safety ring
nut (14) so that it is no longer aligned with the
pin (13);
ALWAYS ensure that the pipe union is effectively
connected.
Connect the gear oil pipe unions (5), fitting the
pipes on the clamp (4).
Fasten the mounting bracket (3) for the gear oil
pipes, by tightening the screws indicated with
relative washers.
Tightening torque
Screw
A3.02).
Nm
Class
20 Nm
B
Advertisement
