Advertisement
Remove the water vent pipe (8), undoing the
indicated union.
Open the clamps indicated.
Remove the connectors (5) from the mounting
bracket.
Mark the positions of the connectors on the
bracket.
Move the knock sensor cables out of the way so
that they do not hinder the subsequent
operations.
Undo all the screws indicated.
Mark the position of the screws, as they are not
all of the same length.
Retrieve the bracket (7).
There may be residual engine oil inside the
heat exchanger.
Clean/dry any pooling oil/water.
Take particular care not to contaminate the
two systems.
Lift the oil-water heat exchanger (A) out of the
relative housing.
Advertisement
