Advertisement
Refit the luggage compartment trim panels (
Refit the removable tool kit cover.
Replacing the EPB electric parking brake Bowden cables
Tightening torque
Fastening EPB Bowden cable - rear hub carrier
Fastening brake pad sensor ground cable
The following procedure is for replacing the right hand EPB Bowden cable.
With the exception of the specific steps indicated, the procedure for refitting the left hand EPB Bowden cable is the same.
Only for vehicles with DCT gearbox. Disable the EPB electric parking brake Autohold function (
Only for vehicles with mechanical gearbox. Disengage the electric parking brake (EPB).
Remove the rear flat undertray section (
FROM Assembly No. 103179 (consult the Spare Parts Catalogue to
identify vehicles not affected by modification)
Insert the articulated wrench (B) in the relative hole on the left of the
tool kit.
Turn the articulated wrench (B) clockwise to completely release the grip
of the parking brake shoes on the rear discs.
The wrench must be turned approximately 50 times to completely
release the parking brake; the brake will begin to release after
approximately 20 turns.
Calibrate the EPB electric parking brake (
At the next Key-ON, the parking brake will function normally, but the
EPB node will register a fault, indicated by the specific warning
lamps on the instrument panel, and by the specific warning lamp
and the message "Parking Brake system revision" together with
the message "Go to dealer" on the TFT display. The errors stored
are C155A on the NPB node (EPB calibration error) and C1313
on the NFR node (parking brake error, indicating that it is
necessary to perform the relative calibration procedure.
E4.07).
Screw
Nut
E3.12).
D3.07).
Nm
Class
8 Nm
B
6 Nm
B
D3.07).
Advertisement
