Advertisement
Refitting the power steering pump
Tightening torque
Fastening pipe - power steering pump
Fastening union connecting pump pipe - steering
box
Fastening front mounting - crankcase and
cylinder head
Fastening rear mounting - engine crankcase
Compressor - crankcase and lower crankcase
shell
Fastening heat shield - power steering pump
Fastening cardan transmission hub - steering box
shaft
Fastening mounting bracket for rigid pipe leading
from pump to steering box - engine
IMPORTANT follow the sequence given for assembling the power steering pump assembly and AC
compressor and for tightening the relevant fastener screws precisely.
Remove the power steering pump (A) from the
engine to afford access to the pipes fastened
to the pump itself.
Mark the position of the pipe.
After marking the position of the pipe to facilitate
correct refitting, undo the pipe union (7) and
detach the pipe (8), retrieving the relative
seals.
Loosen the clamp (9) and remove the pipe (10).
Remove the power steering pump (A) from the
engine compartment.
Screw collar
Threaded union
Screw
Screw
Screw
Screw
Special screw
Screw
Nm
Class
4 Nm
B
35 Nm
B
25 Nm
B
25 Nm
B
25 Nm
B
10 Nm
B
30 Nm
B
4 Nm
B
Advertisement
