Renault Laguna III Manual page 2048

Front driveshaft gaiter, wheel side: Removal - Refitting
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the small securing clip (6) onto the driveshaft.
a Lightly lubricate the driveshaft using the grease sup-
plied with the gaiter to facilitate its fitting.
a Refit the gaiter (7) onto the driveshaft.
a Insert the gaiter lip into the groove of the driveshaft.
a Refit the locking spring ring (8) .
a Spread the quantity of grease around the gaiter and
the stub axle bowl.
DRIVESHAFTS
128412
128416
29A-19
a Refit the stub axle bowl (9) on the driveshaft by strik-
ing the stub axle bowl with a brass drift until the lock-
ing spring ring clicks into place behind the ball hub.
a Insert the gaiter lip into the groove of the stub axle
bowl.
Note:
Check that the gaiter lip is correctly positioned in
the groove of the driveshaft
a Fit the small securing clip on the driveshaft gaiter.
a Refit the big securing clip on the driveshaft gaiter.
29A
109768