Renault Laguna III Manual page 2047

Front driveshaft gaiter, wheel side: Removal - Refitting
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Cut the big securing clip (1) and the small securing
clip (2) using side cutters or a metal saw, taking care
not to damage the stub axle bowl and the driveshaft.
a Push back the gaiter to release the stub axle bowl.
a Cut off the driveshaft gaiter.
a Remove as much grease as possible.
DRIVESHAFTS
93034
128415
29A-18
a Using a steel inertia hammer and a roll pin punch,
hit the ball hub (3) a few times to detach the stub
axle bowl (4) from the driveshaft.
a Remove the locking spring ring (5) .
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace:
- the driveshaft gaiter,
- the big securing clip,
- the small securing clip,
- the locking spring ring.
a Using a parts washer, clean the driveshaft and the
stub axle bowl.
29A
128077
128411