Send-Ring; Shutdown (Voice Entity View) - H3C MSR 20-20 Command Reference Manual

2608 C 173: V IP C
HAPTER O

send-ring

Syntax
View
Parameter
Description
Example

shutdown (voice entity view)

Syntax
View
Parameter
Description
C
ONFIGURATION OMMANDS
send-ring
undo send-ring
Voice entity view
None
Use the
send-ring
Use the
undo send-ring
tone.
By default, the local end does not play ringback tone.
In VoIP view, this command is applicable only after the fast connection function is
enabled. In POTS view, you can configure this command after you carry out the
line command to bind a voice entity to a trunk (other than FXS voice subscriber
line).
# Enable the local end to play ringback tone.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 voip
[Sysname-voice-dial-entity10] fast-connect
[Sysname-voice-dial-entity10] send-ring
shutdown
undo shutdown
POTS/VoIP entity view
None
Use the shutdown
voice entity from UP to DOWN.
Use the
undo shutdown
the voice entity.
By default, the voice entity management status is UP.
Running command shutdown will cause the voice entity unable to make calls.
command to enable the local end to play ringback tone.
command to disable the local end to play ringback
command to change the management status of the specified
command to restore the default management status of