Display Acl Ipv6 - H3C S3100 Series Command Manual

By default, an IPv6 ACL has no ACL description.
Examples
# Configure a description for IPv6 ACL 2000.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] description This acl is used in eth 0
# Configure a description for IPv6 ACL 3000.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] description This acl is used in eth 0

display acl ipv6

Syntax
display acl ipv6 { acl6-number | all | name acl6-name }
View
Any view
Default Level
1: Monitor level
Parameters
acl6-number: IPv6 ACL number, which must be in the following ranges:
2000 to 2999 for basic IPv6 ACLs
3000 to 3999 for advanced IPv6 ACLs
all: Specifies all IPv6 ACLs.
name acl6-name: Specifies the name of the ACL, which is a case insensitive string of 1 to 32 characters.
It must start with an English letter and cannot be named all to avoid confusion.
Description
Use the display acl ipv6 command to display information about a specified IPv6 ACL or all IPv6 ACLs.
Note that this command displays ACL rules in the rule order.
Examples
# Display information about IPv6 ACL 2001.
<Sysname> display acl ipv6 2001
Basic IPv6 ACL
ACL's step is 5
rule 0 permit source 1::2/128 (5 times matched)
rule 0 comment This rule is used in eth 1/1
Table 4-1 display acl ipv6 command output description
Basic IPv6 ACL 2001
named flow
1 rule
2001, named flow, 1 rule,
Field
The displayed information is about basic IPv6 ACL
2001.
The name of the ACL is flow.
The ACL contains one rule.
4-5
Description