Description
Related command:
Example
line
Syntax
View
Parameter
Description
Use the
group-b enable
to complete registers exchange.
Use the
undo group-b enable
Group B signals to complete registers exchange.
By default, Group B signals are used to complete registers exchange.
This command applies to R2 signaling only.
You may need to configure the undo form of this command to accommodate to
the R2 interregister signaling in some countries where Group B signals is not
supported or cannot be interpreted correctly.
register-value req-switch-groupb.
# Adopt Group B signals to complete registers exchange.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] group-b enable
line slot-number:{ ts-set-number | 15 | 23 }
undo line
POTS voice entity view
slot-number: Number of the E1/T1 interface corresponding to a subscriber line.
ts-set-number: Number of the TS group created on the E1/T1 interface.
15: Indicates that the POTS voice entity is to be associated with an E1 voice ISDN
PRI interface.
23: Indicates that the POTS voice entity is to be associated with a T1 voice ISDN PRI
interface.
Use the
command to configure the binding between a POTS entity and a
line
logical voice subscriber line.
Use the
undo line
command to remove the binding.
By default, there is no binding between a POTS entity and a logical voice
subscriber line.
This command applies to both E1 and T1 voice.
command to enable R2 signaling to use Group B signals
command to disable R2 signaling from using
2657