Register-Enable; Registrar Ipv4 - H3C MSR 20-20 Command Reference Manual

register-enable

Syntax
View
Parameter
Description
Example

registrar ipv4

Syntax
View
Parameter
Description
register-enable { off | on }
undo register-enable
SIP client view
off: Disables the SIP registration function.
on: Enables the SIP registration function.
Use the register-enable on
Use the
register-enable off
to disable the SIP registration function.
By default, the SIP registration function is disabled.
# Enable the SIP registration function.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] sip
[Sysname-voice-sip]sip-server master 169.54.5.10
[Sysname-voice-sip] register-enable on
registrar ipv4 ip-address [ port port-number ] [ expires seconds ] [ slave ]
undo registrar ipv4 [ slave ]
SIP client view
ip-address: IP address of the registrar.
port port-number: Port number of the registrar, in the range of 1 to 65535. The
default port number is 5060.
expires seconds: Aging time for registration in seconds, in the range of 60 to
65,535. The default aging time is 3,600.
slave: Specifies the registrar as a slave server.
Use the
registrar ipv4
UA.
Use the
undo registrar ipv4
the SIP UA.
command to enable the SIP registration function.
command or the undo register-enable command
command to configure registrar information on the SIP
command to remove the registrar information from
2703