Poe Enable - H3C MSR 20-20 Command Reference Manual

View
Parameter
Description
Example

poe enable

Syntax
View
Parameter
Description
Example
System view
ac: Specifies the PD disconnection detection mode as ac mode.
dc: Specifies the PD disconnection detection mode as dc mode.
Use the
poe disconnect
mode.
Use the
undo poe disconnect
detection mode.
The default PD disconnection detection mode depends on the device model.
Note that a change to the PD disconnection detection mode may lead to a
power-off of some PDs.
# Set the PD disconnection detection mode to dc.
<Sysname> system-view
[Sysname] poe disconnect dc
poe enable
undo poe enable
PoE interface view/PoE-profile file view
None
Use the
poe enable
Use the
undo poe enable
By default, PoE is disabled on a PoE interface.
c
CAUTION:
If a PoE configuration file is already applied to a PoE interface, you need to
■
remove the application of the file to the PoE interface before configuring the
interface in PoE-profile view.
If a PoE configuration file is applied to a PoE interface, you need to remove the
■
application of the file to the PoE interface before configuring the interface in
PoE interface view.
# Enable PoE on a PoE interface.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0]poe enable
command to configure a PD disconnection detection
command to restore the default PD disconnection
command to enable PoE on a PoE interface.
command to disable PoE on a PoE interface.
2497