Call-Mode; Cid Select-Mode - H3C MSR 20-20 Command Reference Manual

2712 C 179: V FR C
HAPTER O

call-mode

Syntax
View
Parameter
Description
Related command:
Example

cid select-mode

Syntax
C
ONFIGURATION OMMANDS
[Sysname-voice-dial] entity 4 vofr
[Sysname-voice-dial-entity4] match-template 12345
[Sysname-voice-dial-entity4] address vofr-dynamic serial1/0 100
call-mode { dynamic | static }
undo call-mode
VoFR entity view
dynamic: Adopts the dynamic call mode.
static: Adopts the FRF.11 trunk mode.
Use the
call-mode
VoFR entity and the peer voice entity are established.
Use the
undo call-mode
By default, the dynamic mode is adopted.
n
Dynamic call mode: When a call is originated, the frame relay will randomly
■
select an idle FRF.11 sub-channel to establish a voice channel. After the call is
completed, the frame relay will immediately remove the voice channel and
release the corresponding FRF.11 sub-channel. The call control protocol used in
the dynamic call mode is specified by executing the vofr command in interface
DLCI view.
FRF.11 trunk mode: A voice channel is established when you execute the
■
address vofr-static command. The voice channel is directly used to establish
calls. After the call is completed, the voice channel remains until it is manually
cleared. In the FRF.11 trunk mode, you must use the trunk-id command to
configure a PSTN-dialed number for the terminating VoFR entity.
trunk-id and address.
# Configure the FRF,11 trunk mode for VoFR entity 10.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 vofr
[Sysname-voice-dial-entity10] call-mode static
cid select-mode { max-poll | min-poll }
undo cid select-mode
command to configure the mode in which calls between the
command to restore the default call mode.