Card-Digit - H3C MSR 20-20 Command Reference Manual

2728 C 180: V
HAPTER OICE

card-digit

Syntax
View
Parameter
Description
Related command:
Example
cdr
Syntax
RADIUS C C
ONFIGURATION OMMANDS
# Restore the default method of collecting digits of called numbers for the access
number 17909.
[Sysname-voice-dial-anum17909] undo callednumber receive-method
card-digit card-digit
undo card-digit
Access number view
card-digit: Number of digits in a card number, in the range of 1 to 31.
Use the
card-digit
for some access number in the card number/password process.
Use the undo card-digit
By default, the number of digits in a card number is 12 only when an access
number is already configured for the card number/password process (by using the
process-config command).
Note that:
This command is used to configure the number of digits in a card number for
■
the card number/password process. Once the number of digits is fixed, all users
who use the access number must enter a fixed-length card number. Otherwise,
the voice gateway will report an error.
The card-digit command is available in access number view only after you use
■
the process-config command to specify the dialing process as card
number/password process.
gw-access-number and process-config.
# Specify the number of digits in a card number as 10 for the access number
17909.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] gw-access-number 17909
[Sysname-voice-dial-anum17909] process-config cardnumber
[Sysname-voice-dial-anum17909] card-digit 10
cdr { buffer size-number | duration time-length | threshold percentage }
command to configure the number of digits in a card number
command to restore the default.