Vi-Card Reboot - H3C MSR 20-20 Command Reference Manual

Description
Example

vi-card reboot

Syntax
View
Parameter
Description
freq1 and freq2: Two frequencies in Hz. The frequency range is related to the
combination mode. In the case of frequency superimposition or alternation, the
two frequencies fall in the range of 300 Hz to 3,400 Hz. In the case of frequency
modulation, the two frequencies fall in the range of 300 Hz to 3,400 Hz, and the
sum of and the absolute difference between the two frequencies also fall in this
range.
time1: Make time for the first make-to-break ratio in milliseconds, in the range of
30 to 8,192. In the case of continuous play, the value is 8,192.
time2: Break time for the first make-to-break ratio in milliseconds, 0 or 30 through
8,191.
time3: Make time for the second make-to-break ratio in milliseconds, 0 or 30
through 8,191.
time4: Break time for the second make-to-break ratio in milliseconds, 0 or 30 to
8,191.
index: Index of busy tone type, in the range of 0 to 3.
Use the vi-card cptone-custom
customized call progress tone.
Use the
undo vi-card cptone-custom
By default, no customized call progress tone is configured.
After you configure parameters for a customized call progress tone, they do not
take effect immediately. They do only after you execute the cptone country-type
CS command in voice view.
# Customize parameters for a busy tone, with the two frequencies both being 425
Hz, and the make time and break time both being 350 milliseconds.
<sysname> system-view
[sysname] voice-setup
[sysname-voice] vi-card cptone-custom busy-tone 0 425 425 350 350 350 350
vi-card reboot slot-number
Voice view
slot-number: Number of the slot where the voice card is located.
Use the
vi-card reboot
First use command display version or display device to display the distributed
slots of the voice cards in the router.
command to configure parameters for a
command to remove the configuration.
command to reboot a voice card.
2619