Force-Metering Enable; Group-B Enable - H3C MSR 20-20 Command Reference Manual

2656 C 175: E1
HAPTER AND

force-metering enable

Syntax
View
Parameter
Description
Example

group-b enable

Syntax
View
Parameter
T1 C C
ONFIGURATION OMMANDS
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] final-callednum enable
force-metering enable
undo force-metering enable
R2 CAS view
None
Use the force-metering enable
processing.
Use the
undo force-metering enable
processing.
By default, R2 metering signal processing is disabled.
This command applies to R2 signaling only.
When the terminating point supports metering signals, the system may send a
forced release signal instead of a clear-back signal to release the line. This is to
avoid collision between the clear-back signal sent by the called party and the
metering signal.
# Enable R2 metering signal processing.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] force-metering enable
group-b enable
undo group-b enable
R2 CAS view
None
command to enable R2 metering signal
command to disable R2 metering signal