Info-Center Loghost Source - H3C MSR 20-20 Command Reference Manual

2438 C 163: I
HAPTER NFORMATION
Example

info-center loghost source

Syntax
View
Parameter
Description
Example
C C C
ENTER ONFIGURATION OMMANDS
Use the undo info-center loghost
configurations on a log host.
By default, output of system information to the log host is disabled. When it is
enabled, the default channel name will be loghost and the default channel
number will be 2.
Note that:
The info-center loghost command takes effect only after the information
■
center is enabled with the info-center enable command.
Ensure that the IP address input is correct while using the info-center loghost
■
command to configure the IP address for a log host. System will prompt an
invalid address if the loopback address (127.0.0.1) is input.
A maximum number of 4 hosts (different) can be designated as the log host.
■
# Set to output log information to a Unix station with the IP address being
1.1.1.1/16.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1
info-center loghost source interface-type interface-number
undo info-center loghost source
System view
interface-type interface-number: Specifies a source interface by its type and
number.
Use the
info-center loghost source
interface to output log information to the log host.
Use the undo info-center loghost source
interface to output log information to the log host.
By default, no source interface is configured to output log information to the log
host, and the system selects an interface as the source interface.
Note that the info-center loghost source command takes effect only after the
information center is enabled with the info-center enable command.
# Configure the interface Serial 1/0 as the source interface to output log
information to the log host.
<Sysname> system-view
[Sysname] info-center loghost source serial 1/0
command to restore the default
command to configure the source
command to remove the source