Free User-Interface - H3C MSR 20-20 Command Reference Manual

Examples

free user-interface

Syntax
View
Parameter
mode; if either one of these two arguments is omitted, it indicates that no flow
control is performed in the direction specified by the omitted argument. For
example, if you configure flow-control hardware in, the system
automatically sets the local device not to perform flow control on the remote
device.
n
The command is only applicable to asynchronous serial interfaces including AUX
and Console ports.
# Configure software flow control in user interface view (The device does not
support complete flow control.).
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] flow-control software
# Configure to adopt software mode for the active flow control and hardware
mode for the passive flow control in user interface view (The device supports
complete flow control.).
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] flow-control software out hardware in
# Configure adopt software mode for both active and passive flow control in user
interface view (The device supports complete flow control.).
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] flow-control software
# Configure to adopt hardware mode for the active flow control and no flow
control for the passive flow control in user interface view (The device supports
complete flow control.).
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] flow-control hardware out
free user-interface { num1 | { aux | console | tty | vty } num2 }
User view
num1: Absolute number of a user interface. The value range varies with devices,
and normally starts from 0.
num2: Relative number of a user interface, in the following rules:
For the AUX port, the value is 0.
■
For the Console port, the value is 0.
■
2459