Busytone-T-Th - H3C MSR 20-20 Command Reference Manual

Parameter
Description
Related command:
Example

busytone-t-th

Syntax
View
Parameter
Description
string: Area ID, a string of 1 to 31 characters, which consists of digits 0 through 9
and the pound sign #.
Use the command to configure the area ID of the voice GW.
area-id
Use the
undo area-id
By default, no area ID is configured.
The voice area ID is set in VoIP entity view and will be automatically added to the
beginning of called numbers when making calls. If SIP is specified for routing, this
command is invalid.
match-template, address, and entity.
# Configure the area ID 6# for the VoIP voice entity 101.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 101 voip
[Sysname-voice-dial-entity101] area-id 6#
busytone-t-th time-threshold
undo busytone-t-th
Analog FXO voice subscriber line view
time-threshold: Number of busy tone periods for detection, in the range of 2 to
12. A bigger value means a longer busy tone detection time.
Use the
busytone-t-th
for detection.
Use the
undo busytone-t-th
By default, the number of busy tone periods for detection is 2.
You can enable the busy tone detection optionally. Under particular situations,
however, the actual busy tone data cannot exactly match the busy tone
parameters configured for the system. If there is a big difference, the busy tone
may not be detected correctly, resulting in on-hook failures or wrong on-hooks. By
adjusting the time threshold of busy tone detection, you make the busy tone
detection more precise.
Note that before you configure a threshold of busy tone detection, you must test it
fully making sure that on-hook operation can be done properly.
command to remove the specified area ID.
command to configure the number of busy tone periods
command to restore the default.
2555