Display Fr Vofr-Info - H3C MSR 20-20 Command Reference Manual

View
Parameter
Description
Related command:
Example

display fr vofr-info

Syntax
View
Parameter
Description
Example
Interface DLCI view
max-poll: Selects circuit IDs cyclically in descending order
min-poll: Selects circuit IDs cyclically in ascending order
Use the
cid select-mode
the originating side of a VoFR call adopts.
Use the
undo cid select-mode
By default, CIDs are cyclically selected in descending order.
In the dynamic mode, it is possible that multiple voice channels share one DLCI.
The same CID at both ends may lead to a call collision. To prevent call collisions,
you may configure different CID selection modes at both ends
vofr.
# Set the CID selection mode to min-poll on DLCI 100.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] fr dlci 100
[Sysname-fr-dlci-100] cid select-mode min-poll
display fr vofr-info [ serial interface-number [ dlci-number ] ]
Any view
serial interface-number: Displays the FRF.11 sub-channel information on a
specified interface.
dlci-number: Virtual circuit number, in the range of 16 to 1007
Use the display fr vofr-info
information on a VoFR DLCI. You can use the display fr vofr-info serial
interface-number command to display the FRF.11 sub-channel information on a
specified interface sub-interface. The information of all FRF.11 sub-channels will be
displayed if no interface sub-interface is specified. You can use the display fr
vofr-info dlci-number to display the FRF.11 sub-channel information on a
specified DLCI.
<Sysname> display fr vofr-info
interface(dlci)
Serial2/0:0(100)
Serial2/0:0(100)
command to configure the CID selection mode which
command to restore the default.
command to display the FRF.11 sub-channel
vofr-mode cid
vofr-nonstandard 5
vofr-nonstandard 4
2713
cid-type
frag-data
voice-signal