Fax Level; Fax Local-Train Threshold - H3C MSR 20-20 Command Reference Manual

fax level

Syntax
View
Parameter
Description
Example

fax local-train threshold

Syntax
View
Parameter
Description
fax level level
undo fax level
POTS/VoIP/VoFR entity view
level: Level of the energy transmitted by a gateway carrier in dBm, in the range of
-60 to -3. The greater the value is, the higher the energy is. The smaller the value
is, the higher the attenuation is.
Use the command to configure the transmit energy level of a gateway
fax level
carrier.
Use the
undo fax level
By default, the transmit energy level of a gateway carrier is -15 dBm.
Usually the default transmit energy level of a gateway carrier is acceptable. If fax
still cannot be sent when other configurations are correct, try to adjust the
transmit energy level.
# Set the transmit energy level of the gateway carrier to -20 dBm.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 4 pots
[Sysname-voice-dial-entity4] fax level -20
fax local-train threshold threshold
undo fax local-train threshold
POTS/VoIP/VoFR entity view
threshold: Fax local training threshold in percentages, in the range of 0 to 100.
Use the fax local-train threshold
threshold.
Use the
undo fax local-train threshold
By default, the fax local training threshold is 10.
The point-to-point training means that the gateway does not participate in the
rate training between two facsimile terminals. In this mode, rate training is
command to restore the default.
command to configure the fax local training
command to restore the default.
2685