Send-Number - H3C MSR 20-20 Command Reference Manual

2642 C 174: D
HAPTER IAL

send-number

Syntax
View
Parameter
Description
Related command:
Example
P C C
LAN ONFIGURATION OMMANDS
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] select-stop
send-number { digit-number | all | truncate }
undo send-number
POTS entity view
digit-number: Number of digits (that are extracted from the end of a number) to
be sent, in the range of 0 to 31. It is not greater than the total number of digits of
the called number.
all: Sends all digits of a called number.
truncate: Sends a truncated called number.
Use the send-number
Use the
undo send-number
mode.
By default, the truncate mode is used.
Note that:
This command applies to only POTS voice entities. This command is used to
■
control how to send called numbers to PSTN. You can specify to send some
digits (defined by the digit-number argument from right to left) or all digits of
called numbers. You can also specify to send truncated called numbers, namely,
the ending digits of called numbers that match the dot.
Here the dot represents the virtually matched digits. For details, refer to
■
"dot-match" on page 2628 and "match-template" on page 2599.
dot-match and match-template on page 2599.
# Configure voice entity 10 to send the last six digits of a called number.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
[Sysname-voice-dial-entity10] send-number 6
command to configure the number sending mode.
command to restore the default number sending