Delay Wink-Hold; Delay Wink-Rising - H3C MSR 20-20 Command Reference Manual

delay wink-hold

Syntax
View
Parameter
Description
Related command:
Example

delay wink-rising

Syntax
View
Parameter
Description
[Sysname-voice-line1/0] em-signal wink
[Sysname-voice-line1/0] delay send-wink 700
delay wink-hold milliseconds
undo delay wink-hold
E&M voice subscriber line view
wink-hold milliseconds: Specifies duration (in milliseconds) the terminating side
sends wink signals in the wink start mode. The value ranges from 100 to 3,000.
Use the
delay wink-hold
sends wink signals in the wink start mode.
Use the undo delay wink-hold
By default, the duration the terminating side sends wink signals is 500 milliseconds
in the wink start mode.
em-signal.
# Set the duration the terminating side sends wink signals in the wink start mode
to 700 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal wink
[Sysname-voice-line1/0] delay wink-hold 700
delay wink-rising milliseconds
undo delay wink-rising
E&M voice subscriber line view
wink-rising milliseconds: Specifies the maximum amount of time (in milliseconds)
the originating side waits for a wink signal after sending a seizure signal in the
wink start mode. The value ranges from 100 to 5,000.
Use the
delay wink-rising
the originating side waits for a wink signal after sending a seizure signal in the
wink start mode.
command to configure duration the terminating side
command to restore the default.
command to configure a maximum amount of time
2573