Area; Area-Id - H3C MSR 20-20 Command Reference Manual

2554 C 173: V IP C
HAPTER O

area

Syntax
View
Parameter
Description
Example

area-id

Syntax
View
C
ONFIGURATION OMMANDS
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 voip
[Sysname-voice-dial-entity10] match-template 12345
[Sysname-voice-dial-entity10] address ip 10.1.1.2
area { custom | europe | north-america }
undo area
Voice view
custom: Busy tone defined by users.
europe: Busy tone compliant with Europe standard.
north-america: Busy tone compliant with North America standard.
Use the command to configure the type of busy tone for FXO voice
area
subscriber line.
Use the undo area
By default, the busy tone compliant with the Europe standard is used.
This command applies to 2-wire loop trunk subscriber line FXO only. Once this
command is configured, the configuration will be effective to all the analog FXO
voice cards on the device.
When an FXO interface card is connected to a common subscriber line of a
program-controlled switch, if the user on the switch side hangs up first, only by
detecting the busy tone can the router know that the user has hung up. This is
made possible because different switches adopt different cptone schemes with
varying frequency spectrum characteristics, based on which the busy tone can be
identified.
# Configure the busy tone type compliant with the North America standard.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] area north-america
area-id string
undo area-id
VoIP/VoFR entity view
command to restore the default type.