Display Poe Interface Power - H3C MSR 20-20 Command Reference Manual

display poe interface power

Syntax
View
Parameter
Description
Example
Table 641 Description on fields of the display poe interface command
Field Description
Operating Status Operating state of a PoE interface
off: PoE is disabled.
■
on: Power is supplied for a PoE interface normally.
■
power lack: The guaranteed remaining power of the PSE is not high
■
enough to supply power for a critical PoE interface.
power-deny: The PSE refuses to supply power. The power required by
■
the powered device (PD) is higher than the configured power.
power-itself: The external equipment is supplying power for itself.
■
power-limit: The PSE is supplying a limited power. The power required
■
by the PD is higher than the configured power and the PSE still supplies
the configured power.
Different models of device support different operating states.
IEEE class PD power class stipulated by IEEE
Detection Status Power detection state of a PoE interface:
disabled: The PoE function is disabled.
■
searching: The PoE interface is searching for the PD.
■
delivering-power: The PoE interface is supplying power for the PD.
■
fault: There is a fault defined in 802.3af.
■
test: The PoE interface is under test.
■
There is a fault other than defined in 802.3af.
■
pd-disconnect: The PD is disconnected.
■
Different models of device support different power detection states.
port(s) on Number of PoE interfaces that are supplying power
consumed Power consumed by the current PoE interface
Remaining Total remaining power of the system
display poe interface power [ interface-type interface-number ]
Any view
interface-type interface-number: Specifies an interface by its type and number.
Use the display poe interface power
information of a PoE interface(s).
If no interface is specified, the power information of all PoE interfaces is displayed.
# Display the power information of Ethernet 1/0.
<Sysname> display poe interface power ethernet 1/0
Interface CurPower PeakPower MaxPower PD Description
(W)
Eth1/0 15.0
command to display the power
(W) (W)
15.3 15.4 Acess Point on Room 509 for Peter
2489