Silence-Th-Span; Shutdown (Voice Subscriber Line View) - H3C MSR 20-20 Command Reference Manual

Example

shutdown (voice subscriber line view)

Syntax
View
Parameter
Description
Example

silence-th-span

Syntax
View
Parameter
# Change the status of voice entity 4 to DOWN.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 4 pots
[Sysname-voice-dial-entity4] shutdown
shutdown
undo shutdown
FXS/FXO/E&M voice subscriber line view
None
Use the shutdown command to set the voice subscriber line DOWN.
Use the
undo shutdown
subscriber line.
By default, the voice subscriber line is UP.
This command is applicable to FXO, FXS, analog E&M subscriber lines and E1/T1
voice subscriber line.
The POTS interface on the voice interface card will be down and there will be no
sound on the connected telephone after the command shutdown is executed,
and whereas the specified voice subscriber line will be up after the undo
shutdown command is executed.
# Shut down voice subscriber line 1/0.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] shutdown
silence-th-span threshold time-length
undo silence-th-span
FXO subscriber line view
threshold: Silence threshold. If the amplitude of voice signal from the switch is
smaller than this value, the system regards the voice signal as silence. This
command to restore the default status of the voice
2609