Info-Center Monitor Channel; Info-Center Snmp Channel - H3C MSR 20-20 Command Reference Manual

info-center monitor channel

Syntax
View
Parameter
Description
Example

info-center snmp channel

Syntax
View
Parameter
Description
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
System view
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or one
that is defined by the user. The user needs to specify a channel name first before
using it as a self-defined channel name. For more information, refer to
"info-center channel name" on page 2432.
Use the
info-center monitor channel
output system information to the monitor.
Use the
undo info-center monitor channel
channel to output system information to the monitor.
By default, output of system information to the monitor is enabled with a default
channel name of monitor and a default channel number of 1.
Note that the info-center monitor channel command takes effect only after the
information center is enabled with the info-center enable command.
# Set to output system information to the monitor through channel 0.
<Sysname> system-view
[Sysname] info-center monitor channel 0
info-center snmp channel { channel-number | channel-name }
undo info-center snmp channel
System view
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or one
that is defined by the user. The user needs to specify a channel name first before
using it as a self-defined channel name. For more information, refer to
"info-center channel name" on page 2432.
Use the
info-center snmp channel
output system information to the SNMP NMS.
command to configure the channel to
command to restore the default
command to configure the channel to
2439