Fast-Connect - H3C MSR 20-20 Command Reference Manual

Related command:
Example

fast-connect

Syntax
View
Parameter
Description
Related command:
Use the
undo entity
In a global view, use the entity command to enter a voice entity view, and use
quit to return to the dial program view.
n
The entity-number assigned to a VoIP or POTS entity must be unique among all
VoIP and POTS entities.
line.
# Create and enter the voice entity view to configure a POTS voice entity whose
identification is 10.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program
[Sysname-voice-dial] entity 10 pots
fast-connect
undo fast-connect
VoIP entity view
None
Use the
fast-connect
Use the
undo fast-connect
By default, fast connection is disabled.
As there is no ability negotiation for fast connection mode, the ability confirmation
of the two parties is determined by the called gateway. When the router acts as an
originating gateway, you can set whether or not to apply fast connection mode for
each originated call. When the router acts as a terminating gateway, the
configuration of the voip called-start command will determine whether fast
connection is used for call initialization.
Fast connection procedure will be used when both the calling and called parties
support fast connection. Provided that neither the calling nor the called gateway
supports fast connection mode, the system will automatically switch to normal
connect procedure to resume the call.
It is OK to only configure fast-connect command for VoIP voice entity on the
calling gateway. Just after successfully enabling fast connection can the tunnel
function be configured.
outband, tunnel-on, and voip called-start.
command to remove the existing voice entity.
command to enable fast connection for H.323 calls.
command to disable fast connection.
2595