H3C MSR 20-20 Command Reference Manual page 2647

175
ani
Syntax
View
Parameter
Description
Related command:
Example
E1
AND
C
OMMANDS
ani { all | ka }
undo ani
R2 CAS view
all: Specifies the remote end to send the category of the calling party and calling
number.
ka: Specifies the remote end to send only the category of the calling party.
Use the command to enable the terminating point to request calling party
ani
information (service category and calling number) from the originating point
during call connection.
Use the
undo ani
calling party information from the originating point.
By default, the terminating point does not request calling party information from
the originating point during call connection.
n
Configure the local end with this command to support automatic number
■
identification.
This command applies to R2 signaling only.
■
Normally the all keyword is configured. Use the ka keyword only when
■
required by the connected switch to prevent call failures.
cas and ani-offset.
# Request the remote office to send calling number category and calling number
during call connection.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] ani all
T1 C
ONFIGURATION
command to disable the terminating point from requesting