Info-Center Synchronous; Info-Center Timestamp - H3C MSR 20-20 Command Reference Manual

2442 C 163: I
HAPTER NFORMATION

info-center synchronous

Syntax
View
Parameter
Description
Example

info-center timestamp

Syntax
View
C C
ENTER ONFIGURATION
info-center synchronous
undo info-center synchronous
System view
None
Use the
info-center synchronous
output.
Use the
undo info-center synchronous
information output.
By default, the synchronous information output is disabled.
n
Under the current command line prompt, if the user's input is interrupted by
■
system output such as log information, then after the completion of system
output the system will not display command line prompt.
When users need to input some interactive information (non Y/N confirmation
■
information) if the user's input is interrupted by system information, then after
the completion of system output the system will not display command line
prompt but just print the user's input.
# Enable synchronous information output.
<Sysname> system-view
[Sysname] info-center synchronous
% Info-center synchronous output is on
# The user receives trap messages when he/she is about to display the
configurations for an Ethernet interface by inputting the display interface ethe
command. After the system has finished its output of trap messages, it will display
the user's original input, which is "display interface ethe" in this case.
<Sysname> system-view
[Sysname] display interface ethe
%Apr 29 08:12:44:71 2007 AR29.43 IFNET/4/LINK UPDOWN:
Ethernet2/1: link status is UP
[Sysname] display interface ethe
info-center timestamp { debugging | log | trap } { boot | date | none }
undo info-center timestamp { debugging | log | trap }
System view
C
OMMANDS
command to enable synchronous information
command to disable the synchronous