Hookoff-Time - H3C MSR 20-20 Command Reference Manual

Example

hookoff-time

Syntax
View
Parameter
Description
Example
Use the
undo hookoff-mode
By default, no FXS voice subscriber line is bound to the FXO voice subscriber line.
After an FXS voice subscriber line is bound to the FXO voice subscriber line, the
off-hook/on-hook state of these two lines will be consistent.
n
To keep the consistent off-hook/on-hook state between the bound FXS and
■
FXO voice subscriber lines, you must consider the configurations of the
private-line and caller-permit commands when executing the
hookoff-mode delay bind fxs_subscriber_line command. The FXS voice
subscriber line specified by fxs_subscriber_line must be the one to which the
dedicated line number points. In addition, only the bound FXS voice subscriber
line is allowed to originate calls to the FXO voice subscriber line by restricting
incoming calls.
The bound FXS and FXO voice subscriber lines must come from the same
■
device.
# Specify the delay off-hook mode for the FXO voice subscriber line and bind FXS
voice subscriber line 1/24 to the FXO voice subscriber line.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-subscriber-line 1/0] hookoff-mode delay bind 1/24
hookoff-time time
undo hookoff-time
Analog FXO voice subscriber line view
time: Length of the on-hook timer in seconds, in the range of 60 to 36,000.
Use the
hookoff-time
Use the undo hookoff-time
length.
By default, no on-hook timer length is set.
# Set the on-hook timer length to 500 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] hookoff-time 500
command to remove the binding.
command to configure the on-hook timer length.
command to restore the default on-hook timer
2597