Timer Register-Complete Group-B - H3C MSR 20-20 Command Reference Manual

2674 C 175: E1
HAPTER AND
Related command:
Example

timer register-complete group-b

Syntax
View
Parameter
Description
Related command:
Example
T1 C C
ONFIGURATION OMMANDS
This command applies to R2 signaling only.
When the terminating point sends a backward register pulse signal, A-3 for
example, the signal must persist for a specified time period. When the originating
point receives the signal, it sends back a Group II forward signal. When the
originating point recognizes the pulse signal, A4, A6, or A15, it stops sending any
forward signal, and terminates the register signal exchange.
timer register-complete group-b.
# Set the duration of R2 register pulse signals to 300 milliseconds.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] timer register-pulse persistence 300
timer register-complete group-b time
undo timer register-complete group-b
R2 CAS view
group-b time: Maximum time in milliseconds that the originating point waits for
R2 Group B signals, in the range of 100 to 90,000.
Use the
timer register-complete group-b
value of R2 group B signals. After the terminating point switch to Group B, it
should send Group B signals within this time period.
Use the
undo timer register-complete
timeout value of R2 group B signals.
By default, the maximum time is 30,000 milliseconds.
This command applies to R2 signaling only.
timer dl.
# Configure the maximum Group B signal exchange time to 10,000 milliseconds.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] timer register-complete group-b 10000
command to configure the timeout
command to restore the default